How to use your CyberPowerPC UK RGB remote control

How to use your CyberPowerPC UK RGB Remote Control

The remote you have received is to control the lighting on your CyberPowerPC UK RGB fans. Take a look at the image below and then we'll go through each section.

Power Button:

This will turn your fan lighting on and off.

AUTO:

This button will reset the fans back to the original setting which is just a regular rainbow cycle.

M/B:

This button is used to swap the RGB control from the remote to your motherboard software. This is only to be used if your Cyberpower fan hub has been connected to your motherboard via the RGB cable.

S+/S- :

These buttons are to control the speed of the lighting effect currently being used on the fans, there are 3 levels to choose from.. For example if you have the fans cycling through every colour you can increase/decrease the speed at which it will change colours).

M+/M- :

These buttons will change the actual lighting effect/mode on the fans. You can decide whether you want it on full rainbow or fixed on one colour.

Brightness:

Use these buttons to change the brightness level of the lighting effect on your RGB fans. There are 3 levels to choose from.

Manual Colour Buttons:

If a lighting effect does not fit your setup and you just want a single colour to illuminate your room you can choose from 12 pre-set colours options using these buttons.